Skip to main content
Skip table of contents

Network - iXBlue PHINS (Binary Nav message) Angle Speed (UTC) - 30

Description

This is a driver for the iXSea PHINS Binary Nav message. This message contains information that is not present in most messages, such as rotation rates.


Driver Information

Driver

iXSea PHINS (Binary Nav message)

Interface Type

Serial 

Driver Class Type

Counted 

UTC Driver (question)

Yes and No

Input / Output

Input 

Executable

DrvQPSCounted.exe

DrvQPSCountedUDP.exe 

Related Systems

Related Pages


Decoding Notes

All observations in the format description are decoded and converted to the Qinsy default axes and rotation conventions. Note that accuracy of the given rotation rate is limited to 3.6 deg/hour (0.001 deg/s) to 'comply with export regulations'. When the CRC checksum fails, no data will be decoded.

The quality indicator (QI) will be:

  • 0 If the message is decoded correctly and the status is OK.

  • -1 If the message is decoded correctly and the status is BAD.

Database Setup

In the Qinsy Database Setup program, the following systems and observations can be created for this driver:

  • Position Navigation System

  • Gyro Compass

  • Pitch, Roll, Heave Sensor

  • Underwater Sensor: ROV depth

  • Speed Log: angle, speed

  • Acceleration Velocity Sensor: easting speed, northing speed, vertical speed, rate-of-turn X, rate-of-turn Y, rate-of-turn Z

The angle and speed, representing course and speed over ground, are calculated from the easting and northing speed. A moving PHINS will therefore give a more accurate course and speed than a stationary one. It is recommended to use the Qinsy-calculated course and speed.

The driver has two versions: UTC and non-UTC. The UTC version will take the PHINS time from the message as observation time, if there is a valid PPS system defined. In other cases, the arrival time of the message will be used as observation time.


 

 

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.