Skip to main content
Skip table of contents

Qinsy 9.7.7 - Improvements

Online - Controller - Stop recording - Remove confirmation message

If you now click on the square “Stop Recording” button, it no longer asks you to confirm.
This is now similar to pressing the F3 button on you keyboard.

System - Cable Tracker - SMD Artemis - Add additional driver entry that ignores time from message (none-UTC)

The driver would always decode the time from message. However, in some cases this timing was incorrect.
We therefor added an additional driver entry that uses the timestamp upon arrival.

image-20250425-094319.png

Online - Session Setup - Storage - Static Grid - Grid Update Monitor - Automatic - Suppress QGUP warnings and only report in Survey Log

In some situations you would still get a pop-up message from the Controller.
This is not wanted in Automatic mode, so this has been removed.

Console - Geo Config - Show EPSG database version used

image-20250425-093046.png

Online - Controller - Slow response time (blue color)

For some setups, making changes in the Controller, takes a long time to take effect.
Below some examples:

  • Start/Stop recording;

  • Changing Session Setup

    • For example changing active line.

  • Changing Computation setup.

We have made some improvements to speed this up.
Due note that we are still working on this, since we still have situations were this takes quite a long time (>0.300 sec).

So please reach out to support if notice the Controller is responding slow.
Note that it could also be due to:

  • Many Active or Standby Computations;

  • Using large QGFVOM files (>15MB);

  • Using lines with many (>1000) sections;

  • Using tide files with many entries.

JavaScript errors detected

Please note, these errors can depend on your browser setup.

If this problem persists, please contact our support.